| General Parameters: |
|---|
| Status: | Active |
|---|
| Product Description: | Quantic PMI Model No. PMOD-PWR-1030M-ATN-SFF is a power detector module. The operating frequency is 1030 ± 0.01 MHz. Two pairs of forward and reverse signals are input allowing for a 12 bit linear digital output proportional to the input power. A GUI is provided to interface through ethernet and allow MCU programming, unit calibration and setting of the variable attenuators. |
|---|
| Item No.: | 53 |
|---|
| Finish: | Painted Blue |
|---|
| DC Power: | +5 VDC +/-5%
+15 VDC +/-5%
-15 VDC +/-5% |
|---|
| Sigma Input Signal: Frequency: | 1030 ± 0.01 MHz |
|---|
| Forward Input Power (J1): | +37.16 dBm ±5 dB (+50 dBm No Damage) |
|---|
| Reverse Input Power (J2): | +22.21 dBm ±1 dB (+35 dBm No Damage) |
|---|
| Omega Input Signal: Frequency: | 1030 MHz ± 0.01 MHz |
|---|
| Forward Input Power (J3): | +40.83 dBm ±2 dB (+50 dBm No Damage) |
|---|
| Reverse Input Power (J4): | +15.42 dBm ±2.5 dB (+35 dBm No Damage) |
|---|
| Pulsewidth: | 38 µs |
|---|
| Amplitude: | 0 to 5 VDC |
|---|
| Impedance: | 75 Ohms |
|---|
| GUI: | - Interfaces with unit through ethernet connection
- Allows setting of variable attenuators
- Allows calibration of power detectors
- Allows programming calibration table to
microcontroller without need for additional hardware |
|---|
| ER/MNTRVID (J5): | 0 to 5 VDC Amplitude |
|---|
Digital Control Lines
(Other than ER/Sync): | TTL Differential Pairs |
|---|
| J1, J2, J3, J4, J5, J11 Connectors: | SMA (F) |
|---|
| J6 Connector: | 15 Pin Sub-Miniature D Male |
|---|
| J8, J9 Connectors: | 37 Pin Sub-Miniature D Male |
|---|
| J7 Connector: | Molex 0878331031 or Equivalent |
|---|
| J10 Connector: | Ethernet / RJ45 |
|---|
| Environmental Ratings: |
|---|
| Temperature: | -20 ºC to +55 ºC (Operating)
-40 ºC to +85 ºC (Storage) |
|---|
| Humidity: | 0% to 100% Including condensation due to temperature changes |
|---|
| Altitude: | 0 to 10,000 Feet Above Sea Level |
|---|
| EMI: | MIL-STD-461F CE102 |
|---|