| General Parameters: |
|---|
| Status: | Preliminary |
|---|
| Frequency Min: | DC |
|---|
| Frequency Max: | 40 GHz |
|---|
| Reflective / Absorptive: | Absorptive |
|---|
| Isolation: | 65dB Typ, 55dB Min |
|---|
| Insertion Loss: | 5.5dB Typ, 6.8dB Max |
|---|
| VSWR In/Out: | 2.0:1 Typ, 2.2:1 Max |
|---|
| Input Power: | 17 dBm CW Max |
|---|
| Switching Speed: | 5ns Typ, 6ns Max |
|---|
| Rise/Fall Time: | 0.9ns Typ, 1 ns Max |
|---|
| Control Signal: | TTL "1 " = ON |
|---|
| Connectors: | 2.92mm Female Connectors |
|---|
| Size: | 1.2" x 1.3" x 0.50" |
|---|
| Finish: | GRAY EPOXY POLIMIDE COATING IAW MIL-C-22750, TYPE I OVER EPOXY POLIMIDE PRIMER IAW MIL-P-23377, TYPE I, CLASS 1 OR 3
HERMETICALL SEALED |
|---|
| DC Voltage: | +8 to +15V @ 15mA Max
-8 to -15V @ 40mA Max |
|---|
| Environmental Ratings: |
|---|
| Temperature (Operating): | -50°C TO +50°C |
|---|
| Temperature (Storage): | -60°C TO +60°C |
|---|
| Humidity: | THE TEMPERATURE IN THE EXPERIMENTAL CHAMBER WAS 30 DEGREE CELSIUS AND THE RELATIVE HUMIDITY WAS 95%. THE PERFORMACE OF THE DEVICE WAS RESTORED TO STANDARD ATMOSPHERIC CONDITIONS, AND THE DATA WAS MEASURED AND COMPARED AT ROOM TEMPERATURE |
|---|
| Vibration: | AFTER BEING TRANSPORTED BY ROAD, RAILWAY, WATER AND AIR, THE EQUIPMENT CAN WORK NORMALLY |
|---|
| Pressure: | THE DEVICE WORKS NORMALLY WITHIN THE ALTITUDE RANGE OF OTO 4500 M |
|---|
| Salt Spray: | HE CONCENTRATON OF SALT SOLUTION SHALL BE 5%-1%, AND THE EXPERIMENTAL TEMPERATURE SHALL BE 35°C+-2%. TWO STATES OF SALT SPRAY SPRAYING AND DRYING FOR 24 HOURS SHALL BE USED ALTERNATELY. THEN, THE SPECIMEN SHALL BE GENTLY WASHED WITH RUNNING WATER UNDER STANDARD ATMOSPHERIC CONDITIONS, AND THE EXPERIMENTAL RESULTS SHALL BE RECORDED AND COMPARED WITH THE DATA BEFORE DEVICE TEST |
|---|
| Mold Test: | THE EQUIPMENT SHOULD WORK WELL IN TROPICAL CLIMATES IN THE PRESENCE OF MOLD GROWTH |
|---|